Counting matching models…
PS5 snap-on driving wheel with high tolerances. This is a PS5 controller snap-on driving wheel meant for ultimate performance. Tolerances are very tight to eliminate play and sloppiness. All parts are 3D printable, but supports are…
This is a modification of the ubiquitous PS5 controller mini wheel add-on by pixel2: https://www.thingiverse.com/thing:4693372 Here is a video of it being printed and operated: https://youtube.com/shorts/xQ8_doe1zzo My modification…
This is a dashboard switch-hole cover plate for various older Toyota trucks and SUVs. The original came from the other thingi site, item number 2446920 by bgsteveg . I improved it by adding some gussets to keep the tabs from cracking off.…
This is a battery base for the newer Bosch 12v battery modules, which also fits the Dremel 6250+ battery units. I designed this to replace a battery base that I damaged when opening the battery. It can serve as a basis for modern battery…
This funnel will assist with filling the engine oil on a 2001 Yamaha YZF-R6 motorcycle. I cannot say for sure if this would fit other motorcycles, but it is fairly narrow and should fit most M27 threaded filler ports. This was printed in…
This is a replacement button for the outer (energy-saver compartment) door latch of an LG refrigerator. This button latches in loosely and can be removed with a small screwdriver. I used a bit of double-sided tape to keep it securely in…
This small clip holds Sharpie pens of several types and provides a nice hanger-hole for any sort of peg, nail, hook, etc. The Sharpie pen is held by friction of the clip, so smaller pens might require a layer or two of clear tape to fit…
This is a replacement dash lights dimmer knob for 1st generation Toyota Tacoma, 4Runner, T100, and many other vehicles. Specifically, this dimmer knob is adapted to a modern ¼" splined shaft potentiometer, as found in electronic dimmer…
This is a simple cover for a Mean Well LRS-150 power supply that will hold an IEC power cord adapter, power switch, and output terminals/plugs. All hardware used to mount the PS and cover is M3. The cover mounting holes are sized for…
This simple storage unit is designed to hold 24 tweezers or other small tools. Blender was used to design this using boolean subtraction only from a large block. Subtraction seems to be the only reliable way to get good manifolds using…
I developed this snap-on interface for another project to make a racing/steering wheel. Existing models were loose and imprecise, so I created this to provide a tight, solid, and accurate attachment for the PS5 controller. This snaps on…
This is a simple spacer that adapts the 12mm (or 12.7mm/0.5-in) base shaft of a magnifier lamp to fit securely in the inner diameter of the support rod in an inexpensive wire rack shelf. Just remove the end cap, stick the spacer in the…
This is a simple microscope objective plate filler disc for the Swift 80 (and similar) microscopes that require a 100mm x 5mm disc on the objective stage. This print is actually 99mm in diameter to allow for tolerances in different…
This is a welding helmet suspension adapter to allow for the standard Jackson/Hunter helmet suspension rig to adapt to a simple welding helmet that just has holes on the side. Modern Jackson/Hunter helmets have a block of plastic on the…
This is just an odd shape I created for fun. It is simply two triangles rotated 180-degrees and bridged by a smooth transition. Blender source included. It fits nicely in the hand and might make a good basis for a phaser, remote control,…
These are all currently available results.
