Counting matching models…
Only hardware needed is 4 1in long #10-32 bolts. For assembly, first put the bevel gears into their slots in the case. next, slide the hex shafts into the bore in the gears, and finally bolt the top plate onto the main casing). Ill post a…
3 stage planetary gearbox, designed to run with an FRC CIM motor, but it can be used with whatever. If you want to print this to use with a motor, make sure to print in a filament like nylon or PETG/PCTG. I tried with PLA and it melted as…
this is a model of a generic vertical spinner battlebot. To assemble the model, you will need m3 bolts and an m3 tap or just some small self tapping screws. start out by putting the wheel hubs into the wheels and gluing them in place.…
to assemb;e, slide the parts of the back axle together and put in back section of the bot. If you want to drive it with a stepper, attatch it to the 2 L's that stick up in the back of the base, then put the bevel gear onto the shaft. from…
Print the plates in their respected nlabled colors, print at 100% scale for a big tack shooter or print it at 25% for a more reasonable size. then just stack and glue the pieces of the main bpody such that the upper ring holds the top and…
not much too it, thought is that a part drops in the hole to load it then it could later drop it elsewhere. to assemble, put shaft into both sides and glue the sides together
I didnt end up finishing this but im uploading it anyways, feel free to keep workign at it, Id love to see what you can make of it! intended assembly is to put the 2 bent t brackets onto one side of the vice, bolt it down and use a…
spindexer agitators for team 3082. The mechanum wheel casing and dome were the least efficient for weight and speed but the 2 cones were pretty comparable. printed out of pla but could be printed out of anything. use 1inch 10-32 button…
pretty simple, just a 2 part shaft clamp. use 2x 10-32-.5in bolts and 2x 10-32 nuts to pull the sides together.
These are all currently available results.
