Counting matching models…
Remixed for easier printing. No supports needed. Prints well with both 0.4mm nozzle/0.2mm layers and 0.6mm nozzle/0.3mm layers. Looks especially snazzy in coextruded silk PLA.
Do you have various sets of different sized playing cards that are just flopping about without anything to hold them together? Look no further, this card box can accomodate any set! (as long as it's not bigger than your printer) The STLs…
I didn't like the styling of any of the existing lid risers for Bambu Lab printers, so I made my own! My goal was to avoid having to deal with the glass lid to give it ventilation and it's doing its job admirably. The frame slots together…
This is my take on a board for Cult of the Lamb's Knucklebones dice minigame. Travel sized and folds in half for easy transport! With optional recesses for magnets and a printed sleeve to prevent your dice from getting lost in your bag.…
A stand for a safety razor inspired by the Henson Shaving stand. Fits a handle that is 80 mm in length and 11.5 mm in diameter. Can also be scaled in your slicer to some degree if your handle has different measurements. Stable without…
Update 10/2023: I have since made a complete case with a nicer tenting solution . If you don't just want a quick and dirty hack I'd recommend checking that out instead. I recently printed effae's Sofle V2 case but wanted a tenting…
I wanted a case like effae's one , but with a nicer and more sturdy tenting solution than gluing on some legs. So I made my own! This case has a 21 degree angle. Note this is for the V2 non-RGB Sofle. The case and the tenting frame screw…
A tool for removing old FAG/Campagnolo/SKF bottom brackets. I haven't tested whether the hex boss actually works, if it doesn't a pipe wrench does the trick (see photo). I recommend printing this with at least 5 walls. Not sure what the…
A stand for the generic round hygrometers that can be found cheaply on aliexpress. Prints "face down" without supports. Note that this is only for the type with the locking tabs at 11 and 5 o'clock positions.
A snap fit, easy print replacement for the flimsy cardboard counters that are included in Shards of Infinity. Includes SVGs to optionally deboss simplified HP/mastery level symbols into the face of the counter to mark which number is…
I wanted to store my filament more visibly, so I came up with these shelf brackets. They slot into the uprights of an Errex shelf and require two 10mm diameter rods of some kind between them. In my 50cm deep shelf I can fit 7-8 spools per…
If you're like me and think that the box the Shards of Infinity Saga Collection comes in is a ridiculous waste of space, this is for you. Fits the full PvP deck (without coop cards) in card sleeves and six of my counters (see below) in…
These are all currently available results.
