Counting matching models…
THIS IS WORK IN PROGRESS...FYI I made a quick detachable monopod for the picatinny rail on the RPR Stock. I Frankenstein'ed everything from bits and pieces from various sources and some of my own add on's. In short it is designed to slide…
I did like most Ruger rimfire guys do...cleaned my mags... In that it wasn't a bad experience I wanted to make it easier if possible. So I designed a wrench that seems to work well enough to post. This is my 3rd and likely the final…
Since I had medium scope rings available after grabbing my Pro Varmint I needed a little more height for a cheek weld. So I played around and designed this model. The original model “Cheek22mm” is what I went with for my comfort. In turn…
3 Sets of skirts for the Arrma Limitless. Front Wheel skirts, Full side skirts and Rear skirts All printed with PLA .2 layer height 4 top 4 bottom layers infill up to you Speed up to you Note: full side skirt is 305mm long so keep this in…
**Update See Below** Recently aquired a CZ75 Compact PCR. Searched for mags however I only came up with 17 round mags instead of the stock 15 round. I found this file browsing the internet but I cannot relocate it to give credit to the…
Just playing around with designing various bolt knobs for my CZ457 rifle. I have confirmed the threads work but for the initial start of the threading make sure you are lined up well and it goes on straight. I printed mine using carbon…
I do a lot of rimfire Benchrest. I have tried several single shot sleds yet none have really produced a positive result. I came across Steve's sled and printed it out. I like how the bullet sits within the sled as well as the angle in…
After purchasing my CR10-V3 I decided I wanted a better blower setup. I found this one and gave it a spin however after attaching it there was little room for error or adjustment when positioning the mount and as a result it created a…
After receiving my new CZ75 D PCR I decided to make a wedge that helps in removing the take down lever since out of the box for some is hard to pull out. For those who may have older hands or hands with damage it makes it much easier to…
Nothing fancy just a CZ457 22LR Mag holder I made for my safe. Holds 7 mags total I made mine from Carbon infused PLA 3 perimeters 20% infill I attached mine with Goop glue and let it sit over night before use. I edited this model after…
In short this was designed to give me options for Length of Pull for my CZ457 Pro Varmint with the Boyds wood stock. There are 3 models, 25mm, 20mm and 15mm The fit is not perfect around the edges but I got it close. Once mounted it is…
Made my own fan mount for the Arrma Limitless. Seen several guys on YouTube who do not use heat sinks and simply just have the fans laying over the motor which seems to be popular. Its designed to fit the stock brace on the Limitless and…
Made a simple plate to mount my capacitors upon for my RC cars and trucks In this case it is designed for 6 capacitors I used these capacitors in my case and plate is spaced for this size:…
A simple testing gauge for rimfire rim thickness. If you have a set of dial or digital calipers this should fit most all of them. In my case I used an old machining vice to hold my calipers in place to get better more accurate readings.…
I decided to make hole patterns for the standard FC and VTX hole patterns to use when I make mounts for Flight Controllers and VTX's. Both have been used multiple times and the fitment is good. There is a 20x20 and the (now a days) old…
After receiving my Omnix sharpener it became obvious these needed a simple parking rest. I made mine from PLA with 3 perimeters and 25% infil on a Prusa printer. I have edited the original print making it 5mm longer (75mm) and the shelf…
These are all currently available results.
