Counting matching models…
Put a lot of work into getting this a perfect snug fit. Shouldn't interfere with any screen protectors, allows you to set phone flat on a surface too, eliminating camera bump. Screen is protected with a lip. Designed with PLA printing in…
Was getting annoyed at not having anywhere to put the remote for my LG Monitor, so modeled a basic little caddy for it. Three style versions: plain, side cuts & side + front cuts. I only printed front+sides version. The slot is ~43.5mm…
Was annoyed at this charger's inconvenience of just being placed onto a battery, so I made a wall mount dock for it. Just press the charger into place, should be a good interference fit- then mount it to the wall! Two countersunk holes…
Prints flat, with tabs bent into place. Couldn't get satisfactory results on models that were printed fully "3D". I recommend printing in basically any solid filament besides PLA, partially for temp resistance and partially because PLA…
5 slots to store Crucial X9 (or similar size, 10mm thick 50mm wide) external SSDs, as well as 6 SD slots + 2 USB slots and 3 microSD slots. (printed it with overextrusion to try & enhance PETG print clarity, which meant microSD slots were…
A much improved (remodeled from the ground up) version of my replacement control door for the NEC Multisync 3D. Instructions: Recommended to orient as shown in the slicer screenshot. However depending on your printer and how you plan on…
These are all currently available results.
