P
PrintablesChuck Sterling
Human Tooth Card Holder With Base
Printed on an Ender 3 with MH Build PLA (Matterhackers) at 0.28mm layer height. Be sure to set the Z-Seam to the back (away from the slot position, anyway).
- Downloads
- 240
- Likes
- 56
- Rating
- 5
All models
Counting matching models…
P
PrintablesChuck Sterling
CatchAll for bedside
Printed in two sections not requiring support, with interference fit that also negates glue. I printed the example at 0.28 layer height with two walls and 20% infill. I think it would be better at 0.20 layer height with four walls. Later…
- Downloads
- 229
- Likes
- 97
- Rating
- 5
P
PrintablesChuck Sterling
Dozen Roses on Organic Support
Had a lot of trouble with the organic support breaking when the branches got small, then discovered “branch diameter” and set it to 5mm instead of 2mm, which corrected that at the expense of a better looking model. I used Matterhackers…
- Downloads
- 215
- Likes
- 54
- Rating
- 4
P
PrintablesChuck Sterling
TractorTirePencilCup
Started with an excellent tractor tire STL from Ethan Fehrman on Thingiverse, reduced the size to 45% and stacked them side by side in the slicer and overlapped them a little bit to make them appear to be one piece. Exported this assembly…
- Downloads
- 50
- Likes
- 5
- Rating
- 0
P
PrintablesChuck Sterling
Toy Builder Set
Not much to say here. Parts of this are from: https://www.thingiverse.com/thing:2010291 toy tool : Screw and Nut by Goofy34 January 02, 2017 toy tool : Screw and Nut by Goofy34 is licensed under the Creative Commons - Attribution license.…
- Downloads
- 34
- Likes
- 20
- Rating
- 0
P
PrintablesChuck Sterling
GliderWithRubberBandLaunch
Created a glider using Tinkercad (for the left wing, mirror for the right) and Fusion360 (for the rest). The fuselage is in two pieces to be glued together (be sure the slot for the rudder is on top and the launch hook is on the bottom).…
- Downloads
- 33
- Likes
- 5
- Rating
- 0
P
PrintablesChuck Sterling
Birthday 42 Don'tPanic
Change filament color at above 2.0mm level
- Downloads
- 30
- Likes
- 9
- Rating
- 5
P
PrintablesChuck Sterling
2011 Cadillac CTS Door Lock Guide
Designed in Fusion360 to replace a door lock guide on our Cadillac CTS to avoid having to buy an entire interior door panel (since the part we needed is not available separately), and, worst case, having to buy a whole different car……
- Downloads
- 26
- Likes
- 6
- Rating
- 0
These are all currently available results.