Counting matching models…
This is something I have done like 20 years ago in wood, now a new version in plastic! What is this? Long time ago I was trying to build a perpetual motion device with magnet, unfortunately it rotate but like from 0 to 359 degrees :)...…
I needed a belt module to do the inverse so I can clamp a belt in an object, I wanted a real inverse not like most of the design out there where its basically just square. Right now its support Gt2 belt but can support any round belt, if…
I use this version on my new ROSTOCK ULTIMATE that will be available soon. I wanted a different design compared to the others, so the inside of the bearing always touch on different angle along the height of the bearing, making the…
If you want a belt tensioner, this one will work and help to align the wheels better on the X carriage. The belt will be able to be adjusted using a m3 screw, I used 2 x 30mm m3 screw. The belts is tie rapped on the sliding pieces. You…
This is a 3d print design to build your TPU. This is the STEAP version of it. Work in progress! I made an ESP32 WROOM version to control the 3 frequencies. To configure the TPU settings from the ESP32: Upload the firmware using ARDUINO…
The Tronyx X5SA have few problems, one of the problem is the Y carriage, The wheels are not completely straight due to the design, this upgrade make the wheels straight so all 4 wheels touch well the VSLOT. I have 2 part, one bottom (the…
I tried others design out there but cannot make it work for a 40mm of 11mm/16mm of thickness. So after wasting PLA, I decided to make one that work with 40mm fan with thickness of max 16mm. The bottom have m3 holes in a grid layout of…
I am building a Rostock 3d printer and wanted smaller pulley to get a higher definition. Smaller pulley decrease speed but quality should be improved. Instructions This is basically the same Carriage made by Johann (…
I modified the original SCAD my by Johann to change more easily the Ball Bearing Bore size. If you are using a GT2 pulley with 16 teeth for example you need the new updated Carriage that I uploaded and smaller ball bearing for the idler…
This is a threaded rod holder made for Rack-Mount. I was able to buy an old Rack-Mount, It's in my opinion the best case for a 3d printer :) I use this threaded rod holder with the help of my spool holder that clip in the spool. See the…
These are all currently available results.
