Counting matching models…
A fan duct I designed for the Fusion3 F410 due to the stock shroud having poor part cooling performance on the right side of the hotend. Replaces the stock fan shroud and heatsink fan, so may work on other printers with an E3D volcano as…
Quick stand I made for a Mophie wireless charger and my Samsung S21. I cannot guarantee that it will be perfectly lined up for other phone models.
1x2 holder for the Komelon 12ft measuring tape which works with gridfinity. This might work on other measuring tapes too, but I can't make any guarantees
Just a quick tray I made to keep the 3 knives/ multi-tools I keep on my desk more organized. Tested with a Leatherman Signal, Leatherman Micra, and a Benchmade Mini Griptillian, but it will probably work with others as well. Also it has…
The Xiaomi lightbar mount was slipping on my monitor (Viewsonic XG270q) since it was a bit too thick where the mount touched the back, so I whipped up a quick spacer to both move the contact point up, as well as move the front of the…
A 3x5 holder for the Klein Tools MM700 in it's included pouch that works with the gridfinity system.
Basic stand to hold a couple bottles of Pilot Iroshizuku. Nice to keep them off your desk in case of any spills while filling or just to look a bit nicer and more organized.
Just a quick adapter I made to take the exhaust hose from my Danby dual hose AC and vent it out the wall port in my apartment. Use a cut section of ½" foam insulation in the ring to help seal the adapter in the wall port. This is meant…
A replacement valve guide for a Jupiter mellophone. I cannot guarantee that it will work on other brands but you are welcome to try. If you find one where it works, please post in a comment so I can update this. Print instructions…
Simple wristrest for the KBD67mkII which should sit pretty flush with the case and follows the existing typing angle. It prints comes in 2 pieces with little nubs for alignment, so you'll need to epoxy or glue them together after the…
Wall mount for headphones which uses 3 standard thumbtacks to attach to the wall. I designed this because my lease doesn't allow us to screw into the walls or use command strips, but does allow us to use thumbtacks to attach things to the…
I have a portable AC vented out a casement window through a custom polycarbonate insert, but the backpressure from the exhaust was causing the Velcro to peel off of the polycarbonate and for hot air to make it back into my apartment, so I…
The stock spindles for the PrintDry filament dryer were too small to work properly with Overture's spools, but too large to work with inserts, so I made this spindle to increase the size range of spools which can work properly. This can…
Mount for a pop filter on an Audio Technica AT2020 or AT2020USB which fits between the microphone and the included screw on stand mount. Simply unscrew the pop filter from its included mount and clamp it around the post. It prints…
Small carrier for 4oz bottles of epoxy. I've only tested it with JB Weld bottles, but any ~42mm diameter bottle should fit with no issues.
These are all currently available results.
