Counting matching models…
The microphone clips that come with radio transceivers are relatively large. I wanted something that was unobtrusive and would mount easily on the edge of a shelf as seen in the photo. This one fits the bill. Print vertically, no support…
DamienB2 provided a very nice stand for the Tiny SA Ultra, (See the Remix Link) but I could find no equivalent for the Nano-VNA, so I remixed his to fit the NanoVNA and have posted it here. The base and stylus are directly from DamienB2's…
This light bar mounts on the back of the X gantry and shines light directly on the current layer being printed. It was designed specifically for the Ender 3 Pro, but may work with other Ender 3s or any printer that uses a V-slot gantry…
This design aims light under the printhead of the Creality S1 series printers to make it easy to examine the current layer - very important for that first layer! I created a similar system for my Ender 3 Pro, and I really was becoming…
With field day coming in a couple of days, I needed some wire insulators for dipoles that would be strung up at the field day site. I didn't have time to wait for them to be delivered, or to make the trip to the almost-local emporium.…
This enclosure was designed to hold a toroidal balun or transformer for matching to a transmitting antenna. It was designed around the 61mm cores. There are two versions - one with SO-239 connectors on each end, and one with an SO-239 and…
Stack your Solo cups in this along with a marker for friends to label them. My wife saw things like this on Amazon priced from $15-20 and up, and wondered how difficult it would be to make them. Turns out to be not difficult at all....…
Here is my version of the ubiquitous fillament clip. It was inspired by similar versions, but this one is a creation from scratch. Most of the filament clips that I have tried either were too loose on the reel side, and/or didn't grip the…
This is a 45/90 degree triangle template for quiltmakers, with ruler markings for inches, 1/2 inches and 1/4 inches. It is about 3/16 inch thick. A friend of my wife requested this, and I saw it as an interesting challenge. It was…
The Yaesu FTM400 VHF/UHF amateur radio transceiver has a separate control head that can be mounted away from the main body of the transceiver. It comes with a sheet metal stand that can be attached to a top surface, but the back of the…
On the recommendation of a colleague, I purchased the YIHUA 928D-IV Soldering Iron Pen https://www.amazon.com/dp/B0DK995CB5 and I love it. The extremely fine tip is good for soldering the very small SMD components and integrated circuits.…
This mount attaches to the metal rail of a suspended ceiling without requiring any holes in the panel. The two halves slide between the bottom of the rail and the panel and hold the mounting base provided with the detector, which then…
The TMx31 series amateur radio transceivers use a plastic bracket mounted above the PC board to hold the speaker in position against the grille in the top panel. These transceivers are getting a bit long in the tooth, and there are a…
These are all currently available results.
