Counting matching models…
I have a Phillips Norelco Multigroom 9000 that I purchased from Costco. Unfortunately it didn't come with a nice way of storing the guards for the trimmer and I found they were always scattered all over the place. I built this to store…
Stand for M9 Pro Massage gun. 4 slots for each attachment. There's a passthrough as well for the charging cord. Note: Model is in inches, scale to millimeters
I used brass inserts at the hole locations. This ring was printed in ABS and mounted using fiberglass epoxy. Then bodyfilled/sanded/painted into a door window sail. The grill is a 3" universal from amazon that slips into the ring lip.…
A few of our solar lamps were knocked over with the hose and dogs running around and the stakes somehow disappeared. I designed a few of these to be printed without supports and with the layer direction the length of the stake. My…
Simple cap to allow attaching a 0.25" hose to bottle for refilling transmissions. Redline doesn't come with a cap that can accept a small ID hose like many other brands and I had some 0.25" hose laying around. Fits Redline's MTL 1 quart…
This model is to point the Joying 11.5" Android (JY-UZD12N4) Headunit downward and raise it 1". My car double din slot pointed this up way too high and it sat low blocking the vents. This moves the headunit up 1" and tilts it down 17°.…
This is a simple quick mount to have the breakout board mounted on the 2020 extrusion beneath the printer. I designed my own mount for my SKR 3 board that rotates the SKR3 board 90 degrees in comparison to the factory board. Unfortunately…
This is my latest revision of my dipstick tube adapter. I made this for my 2003 Honda Pilot. There are two ways to fill the transmission, either through the dipstick or through the port where a cooling jet is installed. Accessing the port…
I didn't have any spare arrow cutoffs to use ryhno00688's design. This adds the straight section instead of gluing in an arrow shaft. I also brought the tapered section on the top of the adapter down to allow this to sit as high as…
This is a replacement part of my own design for Honda part # 90650-S0X-A00. I confirmed this fits on my 2003 Honda Pilot, should fit quite a few other Hondas as well. I had constantly had issues with leaves being pulled into my air blower…
This is to complement a floor jack wall mount I printed designed by Manning the Printer . This is specifically designed for the Harbor Freight Daytona 1.5 Ton Professional Racing Series Aluminum Floor Jack. Was originally leaning it up…
I use this sensor to get notifications through HomeAssistant when my mailbox is opened. The Ecolink has a dry contact terminal block that I wired an external reed switch to. I had to mount my first one outside the mailbox as the metal…
This is to help in refilling the transmission on a 1st gen Honda Pilot Transmission through the dipstick. This may work with other similar V6 Hondas of this era. I can confirm this works with a 2003 Pilot but can't say it will with…
These are all currently available results.
