Counting matching models…
A quick test for adjusting your Z-Probe Offset while printing with the SV06, it draws the skirt right next to the purge line, check this in your .gcode file with your slicer beforehand. You can adjust your Z-Probe Offset while printing…
This is a bed level test for the whole bed of the SV06, make sure to disable the purge line in your G-Code Start command and probably turn off the skirt or whatever adhesion type you're using as well. Make sure that the PEI sheet fits…
A 200mm Pulling Rod for the Pull Copter toy by Meister Edel with a thicker handle (4mm). 3 variations: 5.5mm thickness for looser fit 5.8mm thickness for easier insert 6mm thickness for the original size
This is a simple soap dispenser bottle head with an inner diameter of 6.54mm in OnShape. It fits my bottle perfectly, I don't know if it will fit yours so measure it up before you print! It takes around 39 minutes to print and uses 4…
This is a print-in-place version of rAthus' “Minimalist Quick Change Toilet Paper Holder”. I looked at his design and modified it to be able to be printed in place with no assembly required. I would still suggest everyone to use the…
Small, simple hearts in 4 different sizes with a small hole to pull a thread through. Layer Height: 0.2mm Print Speed: 50mm/s Nozzle Temp: 215°C Bed Temp: 60°C Wall Line Count: 3 Infill: 30% No supports required.
A camera mount for the “MakerHawk IR Fisheye Pi Camera OV5647” for the SV06. Designed to fit the modular mounting system arms, which can be found here: https://www.printables.com/de/model/185322-modular-mounting-system-arms-customizable…
This is a holder for a bird water bottle, which can be screwed to a birdhouse. Inner diameter of 36mm.
This is a tiny heart box which is perfect for little earrings or small bracelets. Red Filament would look the best obviously, keep in mind that this box is tiny before you print it! No supports required, I set the Wall Line count to 7 for…
This is a simple chopstick holder with the appearance of a bird. It takes approximately 1:10 hours to print. A good place to rest your chopsticks on when eating! Print settings: Layer Height: 0.2mm Wall Line Count/ Perimeters: 15 Top/…
This is an LED mount for the Sovol SV06. It can be adjusted using the modular mounting system arms, I used one 180mm straight arm for the back, 2 axis changers and 2 120mm straight arms. The files can be found here:…
These are all currently available results.
