Counting matching models…
About this part: I made this quick model for an IoT Project I was working on. It is just a simple case with some ventilation for an ESP322 Dev Kit V1 that leaves the USB Port accessible Print settings: Layer Height: 0.2 Recommended…
About this rail: I took inspiration from Gulsifer's models, but they ended up being too loose a fit with how my Ender 3 V2 has been set up, so I went and found the technical drawings for the MGN series rails and designed my own MGN9C…
About this mount: This is a simple BLTouch mount that is slightly adjustable if your Z-Offset is too high. I made this mount for my own Ender 3 V2 as the original mount I received with my BLTouch sensor was advertised for an Ender 3 v2…
About this model: I needed something that's light weight, has a small foot print, has at least 50mm depth and have various size inserts to assist me in organizing my randomly purchased screws, nuts, washers, threaded inserts, etc. for my…
About this little tool: I needed something at least 25mm in length to assist me installing and removing LM8UU bearings from my printed parts with very tight clearances. I used to push the bearing against a table and then to center it, I…
E3NG v1.2 front brace: About this Mod: I had an issue on my E3NG v1.2 where the belt tension caused my front parts to pull closer to each other, making the gantry hard to move in the front, this also inturn got more pronounced when I…
Voron Trident/2.4 aTinyShellScript AWD/2WD Y Endstopmount Model origination: I have aTinyShellScript 2WD plates on my Voron 2.4 350 and did not find a suitable Y endstop mount. I used another from a firend but I lost about 4mm in Y travel…
I have been using a different sensor on my Voron 2.4 and it has been fantastic, but as of late I have been experiencing a lot of inconsistencies and reliability issues. Came across this sensor accidentally whilst searching for a different…
These are all currently available results.
