Counting matching models…
Compact and modular "Infinity Filament Holder" makes it easy to lengthen and shorten your filament rack. I wanted a modular solution that would fit the Lack enclosure, this is the first iteration. The main parts are: Cross Bars - holds…
Enclosure (Housing and Lens) for LED strip. Designed for the i3 LED Light bar ends by SethBon https://www.prusaprinters.org/prints/3267-led-light-bar-prusa-i3-mk2mk3/files Print instructions Designed for printing fast (26 mins) with PETG…
This model repurposes the parts from the rather large Prusa Buddy 3D Camera, into a much smaller package more suitable for a 3D printer. The printed enclosure consists of 3 parts that snaps together, and no screws are needed. As this are…
Compact mount for a disassembled Logitech C920 camera. Made tightly fit the newer model i3MK3S+ x-axis stepper mount/belt tensioner. Optional snap on cover is also included Print instructions Tested on upgraded I3MK3s+ with preset 0.20…
The Filament sensor body from the upgrade package has an error I the geometry, restricting the output PTFE tube so it cannot be inserted all the way. This remix clears the protrusion so it is clear.
A bracket to hold a Laptop or iPad on a WaterRover machine with a good eyeline and room for the rowing band. Print instructions Print 2x side and 2 x mid. gCode is for 1x side and 1 x mid on a plate, so print twice to get all the pieces.…
This is an update to my original Buddy 3D Camera Redux - now specifically made for internal mounting to the Prusa Core One. The design is simplified and still clicks together with no screws, but is also much more robust. I chose to drop…
Filter holder for the CoreOne. Uses the IKEA FÖRNUFTIG (fine filter + carbon filter) filter bundle that is cut in half for space saving and better economics. Can be printed on the Prusa XL Filter are easyly cut with a staney knife, and…
Prevent the LEMO connectors on the main cable from disappearing into the post, & protect the connector and fine thread with this little cap. The reatainer slides sideways onto the lower part on the LEMO in the lower notch, and is pressed…
My Transvideo Cinemonitor died, so I created this bracket to fit the TvLogic F7H on the M1 monitor rods. Print with supports, and high infill level. Use the original rods, tilt bracket and 3x screws The yoke side tilt bearings might need…
Protect your release ring and top connector of the top and bottom stage, trinity head and post extension unit, while they are not in use. First slide in the retention clamp below the release Ring and then press on the cap.
I didn't like the factory tool holding clip, so I designed this small wrench holder to fit on the lower front. It mount to both sides with the back mount fitted, but only the opposite side with Front Mount due to limited clearance. To…
Tool for helping ejecting the press fit 3x8mm magnets from the INDEX tool docks. Place the top and bottom helpers on the tool dock and use a 3mm bolt (approx 15-25mm length) and a hammer to whack them out from the back.
A small adaptor plate to mount the SmallHD Ultra5 Monitor to the existing ARRI Trinity2 brackets for the Small HD 503 (K0.0044368) or Transvideo Starlite (K0.0044367). Remove the 4 existing Torx screws from the ARRI bracket to remove the…
Tired of having to swap 3V coin cell batteries on your Segway X2/i2 remote? This design converts the Segway InfoKey to a 1200mAh lipo battery with 500mA USB-C and QI wiress charging. Takes 1h15m to print on the MK4 with InputShaping The…
These are all currently available results.
