Segway i2, X2 Remote 1200mAh Lipo battery upgrade with USB-C and QI Wireless Charging
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Never run out of battery on your Segway remote angain. No more Primary 3V button cells. Charge with USB-C and QI
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 31
- Makes
- 0
- Views
- 685
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Tired of having to swap 3V coin cell batteries on your Segway X2/i2 remote?
This design converts the Segway InfoKey to a 1200mAh lipo battery with 500mA USB-C and QI wiress charging.
- Takes 1h15m to print on the MK4 with InputShaping
- The internals are simple components from Adafruit. It does require some soldering.
- Everything is fitting tightly and fixed in place with superglue or epoxy
- Full charge is around 2 Hrs.
- Cover the PCBs with epoxy or glue for better weather resistance
- Lanyard Hole
There is a LED indicating status
- RED Charging
- GREEN Fully Charged
- RED+GREEN Battery Error
Printing:
There are two passes:
- Body and lid - Solid filament
- Lens - Transparent filament for the LED Lens/lightpipe
I used Prusament PETG with my MK4 with Input shaping, 0.2mm layer height.
For body and lid: Organic automatic paint on Supports (under the ring bridge and the usb-c connector opening)
I used 40% infill, 3 perimiters, except bottom layer 1 perimeter for better QI logo.
For lens I used Transparent PETG, 100% infill, concentric, no support, lens top facing plate.
Components:
3.3V Regulator for regulating voltage to emulate 3Vbutton cell battery
https://www.adafruit.com/product/4711
USB-C LiPo 500mA charger
https://www.adafruit.com/product/4410
1200 mAh LiPo battery
https://www.adafruit.com/product/258
Universal Qi Wireless Receiver Module
https://www.adafruit.com/product/1901
Small gauge wire: 4 x approx 10cm - 1 x approx 3 cm
Superglue or epoxy