Counting matching models…
I just wanted to clean up my drawer. Organize your hacksaw blades (open holder on left, to allow this to print under 250mm), 9-inch and 6-inch sawzall blades (4 slots), and 14 slots for JigSaw blades. All are 10mm wide. The tall ones are…
I liked the dual battery holders, so I printed two (one mirrored), leaving a gap in the middle. milwaukee packout side mount battery caddy V2.stl I was concerned a hard wack on the edge might damage them, so I printed this bridge to…
Super simple under cabinet or table shelf prints big enough for small and medium remotes. I added a few screw holes. Not overly complex, but plenty strong enough for remotes. I used two command strip type pieces of tape on the lips.…
I use the tick time timer, which is a Hexagon. I made a mount for it. I use double sided tape, but I left room to glue in a magnet in the cavity of the back, if needed. It could be easily modified to be added to the Hexagon peg board, if…
These are all currently available results.
