Counting matching models…
These seal closes the air gaps in the XL. Adding up the gaps on all panels equals a hole 80 mm in diameter, a significant source of leakage for an XL using an enclosure. An additional benefit that I discovered serendipitously is that…
This crankshaft locking tool allows loosening and torquing of the crankshaft pulley bolt at the front of the engine. This bolt needs to be removed to perform the belt service. This tool should be printed with thick walls and at least 80%…
Honda CR-V 46505-SA5-000 Stop Pedal Pad. Not much to say except the part breaks after a while and causes the stop lights to remain on until the battery is dead. People think they have a problem with their battery, and it's just this tiny…
This tool is used to press the seal into the housing. The issue with the seal is that both the inner seal on the waterpump shaft and the outer seal, which seals against the housing, have to be pressed into the housing without stressing…
This cable gland is built in two parts so that it can clamp an ethernet cable with an connector. The hole size is 1". I used this part to pass an ethernet cable from my CNC control box (Centroid Acorn). Standard cable glands were too…
Use this crankshaft spacer after removing the crankshaft pulley to turn the engine with a ratchet. Unlike the spacer described in the workshop manual, this one slips onto the crankshaft and locks into the key. The outside of the spacer is…
The Wahl Figura is an excellent pet clipper but it is difficult to use with fine haired dogs like Doodles. My solution was to make an attachment that hooks up to a standard shop vac and pulls the hair into the path of the blades, then…
The wind stop gaskets on some Ferrari 360 and 430 Spiders are subject to deterioration and cracking. The replacements are expensive (about $1k for all three) and only available as OEM. The current aftermarket wind stops are horrible and…
The wind stop gaskets on some Ferrari 360 and 430 Spiders are subject to deterioration and cracking. The replacements are expensive (about $1k for all three) and only available as OEM. The current aftermarket wind stops are horrible and…
This bird house is 305mm( 12") tall, 140mm (6") wide, and 154mm (5.5") deep. It features a slot for a metal cloth shelf inside to support a nest, ventilation holes on the bottom and top, and if printed with a low infill, dual wall…
This model attaches the Ring Spotlight Cam Battery HD Security Camera and Ring Super Solar Panel. The solar panel is mounted sideways. In order to do this, a bit of plastic has to be trimmed from the mount where it attaches to the solar…
This scraper uses a standard straight razor which fits tightly in the slot at the end of the tool. Depending on the printer, the slot may have to be cut with the razor the first time it's used. I printed this one in CR-PETG (red) at 235C…
The throttle body in the Ferrari 360 is unique to that car and the new stock has been exhausted. The only way to solve a bad throttle body now is to rebuild the existing body with donor parts. This tool is used during the pressing…
This hook can be used to attach something to one side of a doorway. For instance, a puppy block or pet sifter. The hook grabs the molding on one side, and a rubber band holds the “something” in place.
This small plant pot is for fake plants. It has no drain and the bottom of the pot is chamfered 45 degrees for easy printing upside down.
This is a glue down nut keeper for #10 nylock style nuts. The wings with holes help adhesion as the glue can ooze through the holes and in between the wings to secure the nut keeper. If an obstruction blocks one of the wings, it can be…
These are all currently available results.
