Counting matching models…
The Neptune 4 Waste bin is a rectangular waste container that snaps onto the left side of the Elegoo Neptune 4 or Neptune 4 Pro. It may fit other printers with 40 mm square extrusion frames. It's surprisingly useful to have a little bin…
I print a lot of TPU so I prefer not to use a reverse Bowden tube to feed the filament. To reduce drag that stretches flexible filament, I feed the filament from an overhead bearing hub reel holder, down and directly into the extruder.…
This is a small birdhouse, with a geometry optimized for songbirds such as wrens, finches and chickadees. It's small enough to print on a printer with a 150x150x150 mm build volume. It's a very simple one piece print that requires no…
This is a simple organizer and toolholder for the tools and accessories that ship with an Elegoo Phecda laser engraver. Two screws are needed to mount the toolholder. There is a place for the screwdriver, three hex keys, wrench, micro SD…
The Sovol SV08has four hard rubber feet that aren't particularly good at damping vibration so I made some pads that can be placed underneath the SV08 feet with no tools needed and no modification to the printer. The pads raise the SV08 15…
I needed some wall storage to clear up the clutter of DVDs on my desk so I created a simple DVD shelf design that prints with minimal material for the needed strength, and prints without support material. It prints with the small opening…
This is a simple storage and disposal box for several hundred used double edged razor blades. There is a thin slot at the top to accept the used razor blades and they're completely enclosed once inside. When full, simply discard in the…
When feeding filament from above and not using the reverse Bowden tube, there is no PTFE tube supporting the extruder cable, allowing it to droop down, where it can drag over the printed part or more often, get caught between the gantry…
These are the end caps for the hollow top rails on the tailgate and bed sides of an S110P Daihatsu Hijet Japanese mini truck. These end caps are often damaged or missing on older mini trucks and it may be difficult to source replacements…
This is a mount for 8 mm LED strip lighting that snaps into the 15 mm extruded aluminum T slot rail used as the frame for the Sovol Zero 3D printer. I printed it vertically with a 0.2 mm layer height, from TPU-LW. Regular 95A TPU should…
I made a compact ultralight slip case to protect my new DJI Mini 3 drone and RC-N1 flight controller when motorcycle camping. It's as small and lightweight as I could make it. Each of the overlapping side walls are 1.5 mm thick, so the…
This is a simple shelf to organize the supplies needed to clean the optics of laser cutters and engravers, including lens cleaning solution, cotton swabs and alcohol prep wipes. Alcohol prep wipes may not be compatible with some coated…
I bought a Swanlake 20 piece metric and SAE 1/4" hex driver bit nut driver set on Amazon ( B0CZDP1NTV) knowing from the reviews that the nut driver bits were good but the plastic storage holder was not, and also knowing that I have CAD…
This is a simple 1" ball mount, compatible with similar commercial mounting systems. This simple ball mount can be screwed to another part to allow it to be conveniently mounted. This version uses a 6 mm machine screw that protrudes 15-16…
These are all currently available results.
