Counting matching models…
Update April 2024 - I suggest printing the carry handle in two parts, dovetailing it at the picatinny rail. This allows you to print it side down, costing less support material and also getting a more optimal print orientation for…
After improving the internals of my XSLS, I took a look at my old carry handle and wanted to make some improvements. Lowered the carry handle significantly so you can now use a sight. Still, lower profile the sight, the better. More…
I think quivers look tacticool on real steel, so I decided to add one to the SLAB Skeleton stock, the most tacticool stock. I designed the quiver portion myself and used the cheek rest from the Skeleton stock for mounting. I included a…
The original pins for the Corsair aren't easily removable for the long muzzle & stock core. I added a head to those pins so you can convert the Corsair to long or short whenever you want. Print two Muzzle Pins. Only 1 Trigger Pin is…
The MLOK handguard looks awesome but isn't the best for priming as you need to really squeeze it. The easy solution would be an MLOK handstop but real MLOK accessories don't fit. To address this, I merged the handstop with the handguard.…
I remade the shroud from scratch then made the shroud big enough to allow for a BCAR. It can probably fit any BCAR but I've tested with the Worker BCAR without sleeve, ex BCAR, and ex BCAR rev2. Print Instructions: 3-4 walls, 15% infill,…
Printed with P1S with AMS. Personally, I used supports and printed it flat side down, but the supports go under the vents and are very difficult to remove. I suggest angling the whole thing so that the vents print mostly vertically. If…
Converts the Kirin angled talon magwell (from Shellington Labs) to be single dart loading. In prep for a no-mag event, I found I didn't have any old-school blasters at the right FPS. There's a single load mag block for the SLAB and that…
I was graciously gifted a plunger tube. However, it didn't match exactly the suggested 1 ½" OD 1 3/8" ID tube. Instead, it was 38mm OD and 35mm ID. To adapt for this, I enlarged the O-ring areas on the plunger & front so that it would…
Remixed a rear iron sight to be heightened a bit to compensate for dart drop and added holes for inserting a transparent filament. Print Settings 3 walls, 20% Ironing for top surfaces Support underneath plate Assembly Transparent filament…
These are all currently available results.
