Counting matching models…
I decided to make my portable power bank with PD using IP2368. I used 4 batteries 18650 connected in series. The battery balancing board must be attached to the battery holders. No bushings are required! You will need a few screws: 4 x…
Print approx. €0.53–€0.65 excl. taxPreliminary estimate for one variant
4x M3 x 6mm countersunk 4x Threaded Inserts M3 X D5.0 - https://www.aliexpress.com/item/4000232858343.html IP2368 - https://www.aliexpress.com/w/wholesale-ip2368.html BMS - https://www.aliexpress.com/item/32808335825.html (4S 40A Balance)…
Casing for 100W USB PD Power Bank, based on: IP2368 ( https://de.aliexpress.com/item/1005004705604260.html ) Needed: IP2368 board, BMS, 8 18650 Cells, nickel strips, cable, screws. Accents and cable holder are optional. Category:…
Since I replaced the original Bulthaup door lift system, I had to replace the touch fittings with a push-to-open fitting.
This fixes a common fault on Dysons DC24 where the ball becoming loose and clunky and gets significant play up and down on the left side of the ball if you look at it from the front. This play can cause the ball to catch on the HEPA…
I used M2 threaded inserts for the mounting of the pcb and M3 inserts for mounting of the case. Alternatively you can punch the 4 holes open und screw through the case (e.g. to screw it onto wood). I used PETG and it worked fine. PLA…
This is a mount i've designed to fit a IP2368 bi-directional 100w USB charge controller. it mounts with two m2 screws after sliding into the groove. yet to print, hopefully it fits! How I Designed This using tinkercad Category: Electronics
Read the originals' description for assembly and electronics instructions. This was made so that I can print it on a smaller 3D printer such as the Weedo Tina 2.
Consumable straight cup for drill seed system. Printed in TPU. 35 % infill for the rim, 100% infill for the rest.
Panel mount for IP2368 100w bidirectional buck-boost module. I've created this with enough space to install heat-sink on bottom of the board. Even with heat-sink, the module get very hot when I set it to 60w so for higher wattage active…
