Counting matching models…
Manually operated precision 3 part dispenser for 30cc and 55cc tubes/barrels. Does't require supports to print. Recommended layer height 0.2mm or below. 3-5mm of brim recommended. Takes around 4h15m to print with previously mentioned…
Fits your standard 10cc and 30cc syringes. Small drip tray built in. It does definitely need magnets in the base, since it is so tall. These can be printed in one go without supports, but once you get above ~80mm you will want to slow…
I bought syringes of Digikey, not realizing they did not come with plungers 2045-JG30A-BLL-ND. these are 30cc syringes with an ID of ~22.3mm. The piston uses a #018 oring to seal and this works beautifully.
This is a simple flux dispenser designed for 30cc flux syringe. It's a 4 part print that you can simply screw in after printing. I'd suggest printing it at 0.12mm layer height for best results but printing it at 0.2mm works just fine.…
Manually operated precision 3 part dispenser for 30cc and 55cc tubes/barrels. Does't require supports to print. Recommended layer height 0.2mm or below. 3-5mm of brim recommended. Takes around 4h15m to print with previously mentioned…
20mm spacer for the Hanger9 30cc Ultra Stick landing gear to gain extra propellor clearance. Just use 20mm longer bolts to the original mount. Printing in PLA with 4 walls makes a nice solid standoff to spread the load across the bottom…
Stand for 30 / 55cc tube/barrel. One piece desin which does't require supports to print. 3mm brim is recommended. Print with 0.3 layer height or below, 10-25% infill, 2-5 perimeters. Note to position the bottom against the bed because the…
Stand for 30 / 55cc tube/barrel. One piece desin which does't require supports to print. 3mm brim is recommended. Print with 0.3 layer height or below, 10-25% infill, 2-5 perimeters. Note to position the bottom against the bed because the…
