Counting matching models…
The original part (white, right side) broke off, so I made a new one (left side, gray). Printed in PETG. Supports (from build plate only) are required to print this item.
VELA DEL NACIEMIENTO LITOFANO, #CHRISTMASXCULTS https://cults3d.com/:1582995
A compact case for Mitutoyo 500-196-30 or CD-6" ASX caliper. Need 2 M2*20 screws and 4 cylindrical magnets with 6mm diameter and 5mm height.
I made this Mitsubishi ASX (2010) coolant reservoir cap because I broke mine and couldn't find it to buy. One should print this with heat resistant plastic, as the temperatures can get quite high in the motor chamber. Hope it helps!
I printed the adapter with 100% infill with ABS. The holes are slightly smaller than 6mm and need to be redrilled a bit. I glued a protective film to the frame and foam rubber to the inside of the adapter. I secured the screw connection…
I made this Microphone adapter for my Lancer because i really wanted to have the microphone at the original location for my aftermarket head unit in my case its for pioneer but most microphones you can buy on ebay are made the same way...…
There are 2 versions, the regular one and the one with "variant", The one in the picture shown is the regular one albeit its a more earlier version without the cutout slot, but it should work just as fine as mine. Instructions: [If your…
This is a complete enclosure for an ICEpower 50ASX2SE Class D Audio Amplifier module, a 50W stereo amplifier (45W/channel 4 ohms) board made by the Danish company Bang and Olufsen. (Not to be confused with some of the far east "50W"…
The Mitsubishi ASX automatic transmission neutral adapter has been designed and tested for the 2021 model, but is likely to be suitable for other automatic transmission model ranges as well. I designed the adapter in such a way that it…
Backseat lighting house for Mitsubishi ASX (might fit other models) Just remove the backseat handles and use it's screws to put it in place *need to install a wire from the main light in the front to the backseat light is from ebay:…
Smaller light for the backseat of Mitsubishi ASX Light link: https://www.aliexpress.com/item/1005003171890899.html
Halterung für Foxpark 4,8" Rückfahrkamera an Rückspiegelsteg von Mitsubishi ASX ersten Baujahre. Der innere Rückspiegel ist an einem Steg in Form einen Rohres montiert. Auf diesen Rohr wird die Halterung der Rückfahrkamera über der linken…
a holder for the original Arduino Nano screw terminal adapter
Note: The enclosure is 243mm long which fits Bambulab P1P/P1S/X1C and should fit Prusa MK3S+/MK4 or similar but not smaller printers such as Bambulab A1 or Prusa Mini. I made it a single (long) print to simplify the design. Printing Tips…
