1 / 4
8 inch/200mm Mitutoyo Digital Caliper Case (CD-8" ASX) — image 1
1 / 4

8 inch/200mm Mitutoyo Digital Caliper Case (CD-8" ASX)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A case for a 8 inch/200mm Mitutoyo Digital Caliper (CD-8" ASX)

Rating
0 / 5
Likes
2
Downloads
37
Makes
0
Views
154
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution

There are 2 versions, the regular one and the one with "variant", The one in the picture shown is the regular one albeit its a more earlier version without the cutout slot, but it should work just as fine as mine.

Instructions:

[If your printer can fit the already cut version]
1.) Choose which file
2.) Download
3.) Import as 3d models only (As the connectors have negative spaces which cannot be exported)
4.) Adjust (optional)
5.) Print
6.) Insert the dowels onto the holes and connect each respective part As and Bs
7.) Super glue for security
8.) Put the top part on top of the bottom part and make sure the hinges are aligned
9.) Insert Filament into the hinges and cut it to the desired length      [ Check the photos for reference ]
10.) Super glue the filament ends with the ends of the hinges so that it doesn't fall out 
       (or you could insert something small like foam and glue it so that it can't fall out)
11.) Paint (Optional but it would look a whole lot better than the one in the picture

[If your printer can NOT fit the already cut version]
1.) Choose either of the bottom files and the top file
2.) Download
3.) Go to your slicer and cut it accordingly such that it fits your print area (Ideally you should put connectors)
4.) Make sure orientation is correct (for reference, view the already cut version)
5.) Print
6.) Connect each the parts of the respective top and bottom pieces
7.) Super glue for security
8.) Put the top part on top of the bottom part and make sure the hinges are aligned 
9.) Insert Filament into the hinges and cut it to the desired length      [ Check the photos for reference]
10.) Super glue the filament ends with the ends of the hinges so that it doesn't fall out 
       (or you could insert something small like foam and glue it so that it can't fall out)
11.) Paint (Optional but it would look a whole lot better than the one in the picture

[Note]
To open the case, you gently and carefully push the the square-looking button thing and then lift the top case (don't exert too much force as it relies on it bending)
if the button thing isn't bending enough that the upper case can not get released, try cutting the sides of the button thing a little bit until it bends just enough

If you have any feedback please let me know!

Tags