Counting matching models…
This is an replacement battery holder for the DX6 transmitter. Instead of the four AA batteries two protected (longer) 18650 cells can be used. To build this design you also need the following: Battery Springs made of wire (I took mine…
This is a tray console for Spektrum RC Transmitter DX6, DX7, DX8. Transmitter gets fully fixed and can't fall out. The transmitter console can be placed either flat or upright without the transmitter touching the ground. Parts 1 & 2 are…
Replacement trim tabs for your Spectrum DX6i transmitter.
I lost my tool for my HDX68 so i made a printable one.
Spektrum Replacement Roller Menu Scroll Button with metal hex shaft for roller sensor. For DX6i, DX7S, DX8, DX9 transmitters. 0.12 mm layer 15-30 mm/s PETG 1.6 mm hex wrench Insert hex wrench into button side and protrude appropriate…
Für den Druck habe ich auf einem Ender 3S1 gedruckt und mit Cura 5.2 gesliced. Dabei habe ich eine 0.4 Nozzle verwendet und mit PETG gedruckt. Für die Druckeinstellungen empfehle ich folgendes: (So sind nämlich keine Supports notwendig!)…
Fill the bottom compartment with whatever you'd like. I used a few 8g weights and a bunch of rice. Use some M3 screws to secure the covers and you're good to go. You can always add some rubber stick on feet too!
The power push button on my DX6e radio broke and I had removed it. Power on/off was achieved via a pinky finger press on a PCB button (not an ideal situation). This solves that problem and provides a more factory appearance. Print…
I upgraded my Cascadia from an old Tamiya crystal radio to a Spektrum 6Ch one, and needed a shift gate to protect the truck's transmission. This was designed for a G3 DX6, but may fit other Spektrum transmittors. You'll need to adjust…
I knocked up this little mount so I could attach a little Hawkeye Little Pilot 3.5" monitor onto my Spektrum DX6i transmitter. It has a stepped 3mm mount hole (so you can use small washers if required) and uses an M4 bolt and nut to clamp…
This is an add on for a Kurt DX6 that lets you mount a piece of lexan on the back side of the vise to control chips. You can use whatever size you want of 3/16" (4.5mm) lexan or poly carbonate. The print will easily press fit into the…
this in the internal antenna mount for the Spektrum DX6i , Happy Printing
If you need a different vise, leave a comment and i'll look it to making it.
this in the internal antenna mount for the Spektrum DX6i , Happy Printing
This started a a remix of Davross' DX4/5 battery cover but I can't seem to find that Thing now so I am crediting the DX8. The DX4/5 cover came "oh-so-close" to fitting on on the DX6i transmitter. I wanted to just make the minor changes…
