19 models
Our bathroom drawers were getting a bit chaotic so I designed and printed these simple sliding trays that fit on the side slats of the Godmorgon drawers. There are 3 different designs, I might upload some more if I get around to making…
These are furniture legs originally designed for an Ikea Godmorgon bathroom column/high cabinet. Normally, these columns should be screwed into the wall at their upper part, but sometimes that is not possible. However, they should be…
This is a holder that prevents Ikea Godmorgon vanity drawer dividers tipping over.
This is a towel holder for the IKEA Godmorgon Bråbiken wash stand in the photo. 2021-12-03 Improved design. 2020-04-30 Added version without screws. Print instructions Recommended 9 perimeters (at 0.4) on the sides so they are strong.…
I made this replacement foot/stand for the dividers in IKEA Godmorgon drawers based on the original foot (you can see comparison in the photos). To avoid supports, lay it flat on the trapezoid side in the slicer (like you see in the cover…
This is an insert designed for the small container of the Godmorgon set from IKEA. https://www.ikea.com/de/de/catalog/products/50400270/ It holds up to 30 viols of baking aroma like the one from Dr. Oetker or Ruff.
This is a remix of the Godmorgon tray, that can be printed with no supports.
Hooks that can be screwed to the wall directly under the ceiling for Ikea Godmorgon LED light. I had used PETG with 3 perimeters and 15% infill. 4mm holes for the screws
This is a tissue box holder. You can clip it under a glass ottom in a cupboard in order to free the space below it. See my photos for it. I created this for the IKEA GODMORGON cupboard. There are 2 versions here: one for a glass bottom…
GODMORGON boxes from Ikea are great but don't have a handle. Instead, they have a large central hole, that doesn't make them air tight. A serious limitation for food storage, or anything that should be protected from humidity and dust.…
This is a tissue box holder. You can clip it under a glass bottom in a cupboard in order to free the space below it. it's a redesign of one of my other original designs, improved after some months of usage. See my photos for it. The files…
Part to fill the gap between the wall and the light
This fits on the glass bottom tray of an IKEA GODMORGON bathroom cupboard. It obviously fits to many other glass bottom trays… I use it as a holder for my wrist watch when I have to take if off before showering. I don't like to put it in…
Da das Originalteil nicht mehr erhältlich war, habe ich es nachkonstruiert und auch ein wenig verstärkt.Die Außenmaße sind aber genau wie das Original und die Klemme passt jedenfalls bei mir 100%ig und ohne Nacharbeit. Ich habe PETG…
A bracket to mount the smaller of the Ikea Godmorgon boxes onto the Ikea Skadis pegboard. My boxes are quite old now so I'm not 100% certain they will work with newer boxes. The model is printed with the top face on the bottom.
Door hinges may have to be adjusted for correct fit.
A bracket to allow the Godmorgon box to be attached to the edge of a shelf (I use Ikea Ivar). I used 3.5mm countersunk screws, I use my box as a waste bin for the purge lines and wanted it secured near my printer in a way that would allow…
Hangerspacer is for 12mm gaps to mount the wallmounted furniture right. I made the General Round Spacer in 12 an 35 mm. Cut it down in the slicer to reduce height to your needs.
Fix mirror led problem with Ikea godmorgon Category: Bathroom
