Counting matching models…
EDIT: Now updated with a temperature measurement. At 23c ambient the heatsink got up to 38c after writing 250GB's of data to the array. A fan bracket to mount a Noctua 40mm fan (or presumably any 40mmx10 fan) on your PERC H310 HBA. I…
This is a simple full-length PCIe bracket for the Dell PowerEdge H310 HBA / RAID controller. I mounted the card to the bracket with two short M3 bolts and nuts, but you can also use an M4 bolt and screw directly into the plastic. With…
Meant to replace the full-height bracket I received to fit an SFF PC. My pc is the Dell 5060 SFF Re-Uses the Screws my Perc came with. Major diameter of 2.8mm minor diameter of 2.0mm
I lost the IO Shield for my ASROCK H310CM-DVS Motherboard, so I created this one. Print Settings Printer Brand: Anycubic Printer: Kobra Max **Rafts:** No Supports: No **Resolution:** .2 Infill: 10% **Filament:** N/A PLA N/A Notes: Should…
IO shield for the ASRock H310CM-ITX/ac board. Mine came new but without any accessories so I needed to make one. There are two versions available. One with additional stiffening ribs.
To install you must un-route cables from retainer so they come straight out from the motor otherwise fan will not fit. remove heatsink and slide into fan mount to install.
This file is the rear I/O panel model file for the GIGABYTE H310M HD3 model. Although it does not fit perfectly into the ports, it can simply cover the rear panel in cases where there is no rear I/O panel. When outputting, if you set the…
Laptop fan shroud for LSI 9211. You have to file and cut some parts.
The same as the original model just fits a larger fan.
I used 16 or 18mm m3 screws 60x60x15 mm fan Only use the tight version if you need it. The normal one was fine for me.
Capa do microfne do headset da Redragon modelo H310 Microphone cover for the Redragon H310 headset.
This file is the rear I/O panel model file for the GIGABYTE H310M HD3 model. Although it does not fit perfectly into the ports, it can simply cover the rear panel in cases where there is no rear I/O panel. When outputting, if you set the…
Meant to replace the full-height bracket I received to fit an SFF PC. My pc is the Dell 5060 SFF Re-Uses the Screws my Perc came with. Major diameter of 2.8mm minor diameter of 2.0mm
This is a simple full-length PCIe bracket for the Dell PowerEdge H310 HBA / RAID controller. I mounted the card to the bracket with two short M3 bolts and nuts, but you can also use an M4 bolt and screw directly into the plastic. With…
