9 models
Mounts a Pi-Camera Module to the rear gantry extrusion. When used with a camera module 3 - wide this gives you a complete view of the print bed on a 300mm Trident. Install Mounts using hammerhead or roll-in t-nuts and M3x8. Uses M2x10…
Remix from: https://www.printables.com/model/106225-modular-snap-together-raspberry-pi-2b3b3b4-case-w- This fits a 0.96" IPS display, 30x30x7mm fan, and a pi camera cable. It's a pretty tight fit though, I had to trim the dupont…
Remix of ( https://www.thingiverse.com/thing:2772725 ) Made a bracket that holds the camera in place by sliding into slot instead of requiring back plate with zip tie. Made this to work with PiCam V1.3.. should work with V2 but not sure.…
This piece can be used to attach m12X0.5 thread lenses to the picamera Print instructions Category: Camera Instructions Remove the original lens from the Picamera (better explained here:…
I wanted a simple PiCamera holder. Here it is. Mount it with a M3 Nut for the 30x30mm extrusion and a M3 screw. I used a PiCam v1.3. Support the upper tubes in the camera module.
I needed a way for a Picamera to take pictures of highly reflective surfaces. Conventional lighting created too much glare, so I went with a different solution; a microscope light. This item is available at this link:…
Sercomm icamera 1000 2000 2 Gasket Gasket for a Sercomm icamera Fits models: 1000 2000 (icamera 2) Print this in TPU Print settings: 0.4mm nozzle 0.2mm layer height Default Prusaslicer TPU settings
Remix of Blejdfist's design, with added fan vent. Components; Raspberry Pi v4B Argon Neo case Waveshare POE hat (D)
