6 models
I decided to make my portable power bank with PD using IP2368. I used 4 batteries 18650 connected in series. The battery balancing board must be attached to the battery holders. No bushings are required! You will need a few screws: 4 x…
Print approx. €0.53–€0.65 excl. taxPreliminary estimate for one variant
4x M3 x 6mm countersunk 4x Threaded Inserts M3 X D5.0 - https://www.aliexpress.com/item/4000232858343.html IP2368 - https://www.aliexpress.com/w/wholesale-ip2368.html BMS - https://www.aliexpress.com/item/32808335825.html (4S 40A Balance)…
Casing for 100W USB PD Power Bank, based on: IP2368 ( https://de.aliexpress.com/item/1005004705604260.html ) Needed: IP2368 board, BMS, 8 18650 Cells, nickel strips, cable, screws. Accents and cable holder are optional. Category:…
This is a mount i've designed to fit a IP2368 bi-directional 100w USB charge controller. it mounts with two m2 screws after sliding into the groove. yet to print, hopefully it fits! How I Designed This using tinkercad Category: Electronics
Read the originals' description for assembly and electronics instructions. This was made so that I can print it on a smaller 3D printer such as the Weedo Tina 2.
Panel mount for IP2368 100w bidirectional buck-boost module. I've created this with enough space to install heat-sink on bottom of the board. Even with heat-sink, the module get very hot when I set it to 60w so for higher wattage active…
