Counting matching models…
Use case: I found it rather annoying and hard to not make a spill while adding oil to my Z4 with the N54TU engine. There's not enough room to maneuver an oil container without making a small spill. This should help resolve this issue. I…
A case to connect a Sensirion SEN5x series air quality sensor to a D1 mini for wireless reporting. Based on the mechanical design-in example for SEN5x & SPS50 .
This is a mount for the Gen5x Ridgid folding hybrid light. It's a much tighter and more secure fit than using two screws in the stand eyelets. I printed using 20% infill which is the minimum infill I'd use, next print I'll probably do 50%…
Air quality sensor SEN5x MH-Z19 SSD1327 Hello; I would like to present my take on air quality sensor made out of: ESP32 board SEN55 - PM/NOx/VOC sensor MH-Z19 - CO2 sensor SSD1327 - display Chassis will require : Filaments Geetech marble…
SEN55, SEN54, SEN53 Environmental sensor mount. Print with support.
Over designed bracket to hold the Ridgid 18V Pane Light on the wall for both storage and for use above my workbench. My garage door blocks my overhead lights and this is a great alternative to get some extra light on the workbench as well…
SEN5x Sensirion environmental sensors (PM, RH/T, VOC, NOx) holder for installation in E113 (IP54) box Project Page (CZE): https://www.klosko.net/blog/=clanek=monitor-kvality-ovzdusi-s-cidlem-sen5x
I added a 45 degrees ledge to support the lip of the funnel, reducing the need for supports.
Work in progress... https://github.com/FreddieHong19/Open5x Use 6201 Ball Bearing
https://github.com/FreddieHong19/Open5x Use 6201 Ball Bearing
This is a housing for the ESP32 board WT32-SC01 with 320x480px LCD and two sensors: - SEN5X (PM, VOC, Temp, Humidity, NOX) - all SEN53, 54 and SEN55 have the same form factor - SenseAir S8 (CO2) The back cover is holding the sensors in…
This is custom top shell for Aoostar GOD and Tianbei MN5X mini PCs. And probably other brands that use the same supplier. Mine is Aoostar GOD78 with Ryzen 7 7840H. While it works OK as is, when you push CPU a bit it heats up to 86+ °C,…
I went to gridfinitygenerator.com and created a 2x5x12 and a 3x5x6 bin, then I used Blender in order to merge both bins to a single 5x5 bin with 2 rows being 12 units tall and the other 3 rows being 6 units tall, because I wanted to make…
I added a 45 degrees ledge to support the lip of the funnel, reducing the need for supports.
I went to gridfinitygenerator.com and created a 2x5x12 and a 3x5x6 bin, then I used Blender in order to merge both bins to a single 5x5 bin with 2 rows being 12 units tall and the other 3 rows being 6 units tall, because I wanted to make…
