14 models
The housing consists of two parts. The cap is snap-in. The HDMI and USB-C ports are easily accessible and not recessed into the housing. The housing has a cutout that allows access to the microSD card without disassembly and holes for…
2parts, held together by four M3 10mm screws and nuts. no supports needed. OpenSCAD source available. New : Optional top that houses 4x4x4mm NdFeB magnets. Even half-populated it will stick to any metal case (just be aware of magnetic…
Simple enclosure for the Silpeed NanoKVM-Lite. I printed with no top or bottom layers and 30% hexagon infill for additional airflow. No supports needed. Made in FreeCAD 1.0rc2, source file encluded so feel free to mod it to your liking.
This is a custom-designed protective case for the Sipeed NanoKVM Lite, an open-source KVM switch that allows you to control multiple computers with a single keyboard and mouse. The case is designed to provide both protection and…
Both In is for having both ethernet and the IO behind the rack ear. I use this configuration to mount the NanoKVM to the back of a rack and use keystones to pass through all the IO and Ethernet through my patch panel. Eth Out is for…
By default, the nanoKVM Lite doesn't include a case. I found some existing designs, but they were quite bulky, used a lot of material, and blocked ports unless you used the same cables as the original creator. I've created my own…
Holder for a nano kvm lite power/data splitter using 3 usbc breakouts. These breakouts are wired so one port is power and one port is the data. both get combine on the kvm side. I designed this holder around these breakouts.…
Some versions of the NanoKVM come with a non-standard PCIe bracket that is too high for the mount hole. This model is based on my measurements but has the correct height. It's somewhat flexible but does not compromise the structure when…
This is a simple 3D-printable mounting bracket for a Sipeed NanoKVM , designed to mount the device on the side of a rack homelab setup. It's universal, so you can print for either left/right mount, buttons and OLED display are accessible.…
Split to objects in slicer. You can make the feet using hot glue.
This is a simple 3D-printable mounting bracket for a Sipeed NanoKVM , designed to mount the device on the side of a rack homelab setup. It's universal, so you can print for either left/right mount, buttons and OLED display are accessible.…
There are other NanoKVM cases but I wanted one that would print without supports for an easy and good looking case. This model was designed with the heat sink in mind, but it is optional. To install it is very simple: place the NanoKVM…
NanoKVM Lite case with OLED and additional rackmount “click in” bracket if needed. 2 variants of fixation.
Split to objects in slicer. You can make the feet using hot glue.
