Counting matching models…
The STL file from the Foxeer website did not work for me. So I mixed it with the model from Thingiverse , created by robthomson . I printed it without support, using pet filament—front facing down. I had a minor issue in the top right…
This is a demonstration model to show that the linear increase in spring force does not correlate to a linear increase in launch torque. Instead the launch torque will have a logarithmic behavior as the angle of the spring force…
This is a strap buckle intended to replace the poorly designed OrqaFPV goggle strap buckle which in my case broke along with other problems with these goggles. There a five parts for each buckle: 2 x Pins Stainless Steel 2mm X 40mm -…
What is it ? A lightweight, low profile slick 3d print that locks IPD and Focus settings of the Orqa FPV One.Pilot (v2) Goggles. Sick of adjusting your optics between every session, pack, or after wiping the lenses got your settings all…
After accidentally mixing up my pocket packs and plugging 4s into my Orqa goggles, blowing the sh1t out of them, and costing me about £300 in repairs..... I decided to make this. Print the lid and top Pop in the DC converter (the right…
Orqa Soccerball SOCR.Jogo Drone Holder
I designed an easily printable and clean looking mount for putting sharkbyte RX on your orqa goggles. flip it over so the flat part is on the print bed and it will print with no supports, even the holes are designed for no overhang. you…
I designed an easily printable and clean looking mount for putting sharkbyte RX on your orqa goggles. flip it over so the flat part is on the print bed and it will print with no supports, even the holes are designed for no overhang. you…
This is a demonstration model to show that the linear increase in spring force does not correlate to a linear increase in launch torque. Instead the launch torque will have a logarithmic behavior as the angle of the spring force…
