Counting matching models…
Baby's first upload! I was able to print this with no brim, although PrusaSlicer recommended one. Fresh roll of PLA, Push Plastic brand, a US vendor. I'll print it in PETG in the future, but I was trialing a lot of fits for this. Also…
Print approx. €0.14–€0.17 excl. taxPreliminary estimate for one variant
A little stand for ASUS Vivobook Pro 15, I believe it will be usable for different notebooks too. (model is withou “Y” logo) My printing setting: Layers - 0,3mm DRAFT Material - PLA/PETG Filling ~30% No supports needed
Takes a lot of time and material. Recommended supports for the logo are detachable snug.
The Vivobarefoot Ultra III aquatic shoes are great but the laces can cut thought the soft rubber easilly. These lace hole reinforcements will help prevent that.
I received an old Asus laptop that broke at the hinges as the piece sheared off but the wiring was still connected. It was a perfectly functioning laptop but the hinge just couldn't move without risk of further damage. I constructed a…
Easy to print enclosure for connector (Wago like) for two cables of two 1.5mm² cables. Like the ones used in lampshades. This is to protect the wago for direct rain and dust for outside. I used it for low voltage leds and have no…
Printed in PLA with coarse layers, 20% infill.
Quick edit, it holds the laptop upside down but its a secure fit and a quick print. Should work with any filament, print vertically(the long way)
A tactical 25mm strap keeper designed specifically for the Czech Army ( CZE VOBU 2018 ) plate carrier belt system. This low-profile clip helps keep the loose end of the tactical belt tightly secured to the main strap, preventing it from…
For my dehumidifier a needed a quick solution to press a button and get the status of the power LED. The DH is switched corresponding to daylight (free PV energy). The quick and dirty sensor case was done by myself. I used the following…
I found this hotplate for super cheap in a store and decided it would be a good project to learn more about Fusion 360. I printed the replacement shell out of wood PLA and then sanded and stained it. The button is printed out of clear…
Looking for a complete set of alphabet and symbol STL files? ✨ You’re in the right place! These fonts are free to use from fonts.google.com , but I’ve already done the work of converting them into ready to print STL files, all from 149…
Add-on for the ASUS Vivobook 63mm charger
Raises the laptop up, stable balance. Space below for Bose portable bluetooth speaker. Used CA glue to assemble. Don't glue the top piece, it lifts off to remove the laptop from the stand. Used tiny drill bit to ream holes for the power…
The Svoboda trigger space is a piece to put into the receiver to prevent the lever mechanism from unscrewing itself. The Svoboda trigger overtravel is a simple block to put behind the trigger to prevent the gas mechanism from shutting…
Studenti se seznámí s principem "Pythagorův pohár". Necháme studenty samostatně experimentovat s hotovým výrobkem a navrhnout důvod proč a jak “kouzlo” funguje. Dále si vytvoří svůj vlastní.
Takes a lot of time and material. Recommended supports for the logo are detachable snug.
I received an old Asus laptop that broke at the hinges as the piece sheared off but the wiring was still connected. It was a perfectly functioning laptop but the hinge just couldn't move without risk of further damage. I constructed a…
Quick edit, it holds the laptop upside down but its a secure fit and a quick print. Should work with any filament, print vertically(the long way)
https://www.vetrelciavolavky.cz/sochy/reva-divka-s-hrozny
