Quick and Dirty ServoBot (Switch Bot)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Press a Button and monitor the power LED
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
For my dehumidifier a needed a quick solution to press a button and get the status of the power LED. The DH is switched corresponding to daylight (free PV energy).
The quick and dirty sensor case was done by myself.
I used the following model to create my servo case:
https://www.printables.com/model/479846-9g-servo-model-for-subtraction
And this model for the ESP case (modified to fit my needs [Hole bigger + taller]):
https://www.printables.com/model/64517-nodemcu-esp-8266-case
I used AI to get a base code for the ESP8266, that was modified to fit my needs.
Needed Hardware (Amazon Affiliate Links):
Photo Diode - https://amzn.to/4myccq2
Servo G9 - https://amzn.to/43dGrLv
ESP8266 - https://amzn.to/43muJgg
10k Ohm R - https://amzn.to/4myGsRS
If anybody needs a wireplan, please send a comment. ;)