Counting matching models…
This is… the rear SRS cover for the W203 Sedan! This model is the remaster of the design created by me, based on the original Mercedes part! Although this was created with a sedan part, it could work on the Station or the Coupe. This…
Replacement knob for the climate controls
NEW GENUINE MERCEDES BENZ W169 W203 W204 W209 W212 - BALLPOINT PEN HOLDER Since my pencil holder cracked, I drew new one, which are a little stronger in some corners, but it is very similar to the original one. Work perfectly! Printed…
This is… the rear SRS cover for the W203 Sedan! This model is the remaster of the original design by Mercedes-Benz, with a few improvements! Although this was created with a sedan part, it could work on the Station or the Coupe. This…
This is a cap to protect and beautify the shock absorber bolts of my Mercedes W203. I printed on PETG to withstand the heat coming from the engine. Print with 25% infill. No supports needed.
Print on PETG with 25% infill. No supports needed.
Replacement knob for the climate control panel
Housing for CVBS/AHD camera of Mercedes Benz license plate lamp. You can use this adapter / fixture for camera, which comes with android auto headunits, as replacement of original transparent plastic in licence plate light or combine it…
The goal here is the same as the original however i found that the parts i had when testing the original didnt work quite as i had wished. One concern i had was waterproofing- this led med to design a clip style close to the original that…
The lid on my boot lighter socket broke so I made this one. Printed on PETG with 35% infill with no supports.
W203 C200 License Plate Light Housing, modelled to stock dimensions . Part no : 203-820-0556-64-OR or A203820055664 You will need the stock screws & festoon bulb holder prongs. Some insulation tape could also be used on the back. I've…
This model replaces the original Mercedes C180 Kompressor 2004 W203 decorative strip Clip, if the original ones are missing or brocken. Print in PC (Polycarbonate) PETG will break do to stress and extreme thermal conditions. I'm sorry for…
Designed um in die hintere Mittelarmlehne zu passen. --- Designed to fit in the back arm rest ->not tested yet
W203/W209 AC knob. Anchors for C220/C230/C240 added, using original mount. Print in PETG/ABS (NO PLA to avoid heat warp)
This is a fishing reel repair part for getting the line winder working on an Okuma Coldwater level wind reel - Model CW203D. Okuma part #: 17070009 UPC#: 8400834225 Part name - Transmission gear. This is a model for a temporary repair. It…
Would suggest printing it sideways, uses more material for supports but much sturdier also better to use “tree” support, hope this will be useful for someone
W203/W209 AC knob. Anchors for C220/C230/C240 added, using original mount. Print in PETG/ABS (NO PLA to avoid heat warp)
These are the replacement clips for the W203 roof trim (sedan), part number A2036900013. The model was reinforced, when compared with the original part. For ideal compatibility, print both clips, with a heat resistant filament (ideally…
