1 / 5
P1S Fume Extraction Fan System for 100mm Ducting — zdjęcie 1
1 / 5

P1S Fume Extraction Fan System for 100mm Ducting

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic adaptors for a) Mains powered inline 100mm duct fan, b) Sliding window adaptor c) Joiners for 100mm ducting.

Ocena
0 / 5
Polubienia
9
Pobrania
38
Wydruki
0
Wyświetlenia
608
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Disclaimer

If you are not confident with tackling mains powered projects seek professional advice. I am not liable for any issues that may arise from incompetent or unauthorized wiring practices!

Fan

The fan was purchased from Aliexpress https://www.aliexpress.com/item/1005007329266580.html

The electrical connection housing screws onto the metal fan casing covering the existing cable entry hole so that the fan wiring passes into the housing.

The mains wiring is connected to the fan wiring with a 3 section “choc-block” barrier strip connector which fits over the two internal pins of the housing.

The earth wire of the mains wiring is secured to one of the connecting screws. Most importantly, the securing screws have star washers to ensure good electrical connection to the metal frame of the duct fan.

The lid is secured with 4 x M3 screws which screw into matching heat set inserts in the connection housing.

The two magnetic duct couplers that attach to the fan simply snap on. The one that you choose to fit adjacent the electrical housing needs to have a small section trimmed to fit.

Duct Couplers

The inline magnetic duct couplers slide onto the 100mm diameter flexible ducting and are secured with cable ties. The non magnetic end of the inline couplers have a small lip to ensure the cable tie cannot slide off once it has been tightened. 

Sliding Window Adapter

This adapter is designed to slot onto the aluminium window frame extrusions. You will likely need to modify the slots to suit your specific window frame and layout. A plywood filler is to be added in the ~50mm wide gap above the adapter to form a seal.  

Fitting Magnets

To fit the magnets I used pliers to carefully press each one into its socket until it sits flush. Make sure the orientation of each magnet pole is such that when a male and a female adapter are brought together they attract each other - how sweet :) 

It would be wise to make all the male adapters and then all the female adapters - ask me how I know.

The last step yet to be designed is the magnetic adapter for the P1S printer 

 

 

 

Tagi