Magnet Insertion Tool v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
UPDATE 24.09.2024
- 8x3mm Magnet Variant added (not tested by me as i dont have those magnets. These magnets may be too strong for this variant)
UPDATE 20.09.2024
- 6x3mm Magnet Variant added
INTRODUCTION
v2 of my Magnet Insertion Tool, with
- optimized Tip size
- trigger suspension
- self reloading Magnet Magazine
PRINTING
All parts are already in the correct orientation. “Tip” is the only part that requires Support Material.
I printed everything in PLA. 0.2mm Layer height, 0.4mm Nozzle on a Anycubic kobra 2 Pro.
FILAMENT
i used PLA+ from Elegoo but any other Pla should work as well
PLA+ from Elegoo (reflink)
HARDWARE
Magnet sizes currently tested and supported:
- 5x1mm
- 6x2mm
- 8x2mm
- 6x3mm
- 8x3mm (not tested)
Other Hardware you need:
- 2x M3x6mm
- 3x M3x10mm
- Rubberband
- 3x Magnets of selected size
ASSEMBLY
There is a PDF attached to the files with assembly instructions as well as some simple Assembly steps shown in the Video
I reccomend printing 2 tools. 1 for each pole of the magnet. I printed one in Red and one in blue.
Support my work by becoming a PATREON
or Buy me a Coffee