Comgrow Center Bearing Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a center Axle to be used with bearings, installed on a one of my Spool Holders with only 2 of the 608 Bearings
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Printer: Ender 3 s1 w/Sonic Pad & Ender 3 V3
Material: PLA
Print Temps: 205 & 70
Nozzle size: 4mm
Layer height: 2mm (Good Quality)
Speed: 100mm p/s
Supports: NO
Bed Adhesion: NO
This is a very simple Bearing Axel to be used with the Cradle support found here: Download Page Here
I wanted to make a Spool Holder that had low friction and only used 2 of the 608 Bearings instead of 4. (I got mine from Amazon)
It was important to me that it have NO SUPPORTS, NO BED ADHESION and simple to use, and I think I have it in this design.
PLEASE leave a comment with pictures to give me input on possible suggestions to make it better.
Enjoy!