1 / 9
Lightweight magnetic Skadis holder for IKEA Styrbar remote control — zdjęcie 1
1 / 9

Lightweight magnetic Skadis holder for IKEA Styrbar remote control

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holds a IKEA Styrbar remote on a Skadis pegboard with magnets. Mounted with 2x M2.5 Skadis T-nut.

Ocena
0 / 5
Polubienia
1
Pobrania
19
Wydruki
0
Wyświetlenia
327
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bedroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted to put an IKEA Styrbar smart home remote on a pegboard. I didn't like that the holders I found, so I made my own.

There are 2 versions:

  • V1: minimal, just a thin horizontal print
  • V2 (recommended): bigger, rounded rectangle

I recommend V2. V1 holds the remote just fine, but pressing the remote's buttons while it's mounted will make it wiggle, which is annoying if you want to use it this way. V2 adds more backing to all sides of the remote, letting you press buttons with no wiggling.

Prerequisites

You will need:

  • 1x this printed part,
  • 6x neodymium magnet, 5 mm diameter, 2.5 mm height (I just happened to have those on hand),
  • 2x Skadis T-nut, 2.5 mm variant (which in turn needs 2x M2.5 hex nut),
  • 2x countersunk M2.5 screw or appropriate length - I used M2.5x12,
  • some glue, like Loctite.

Printing

V1 prints without supports oriented with the short side faces on the build plate:

V2 will print without supports with the front side on the build plate (i.e., the magnet pockets and T-nut alignment guides facing up):

Assembly & installation

The part (both in V1 and V2) has 2 sides. One has round pockets for magnets - that one is the back side.

The remote control has magnets inside is on the left and right side.

Take your 6 magnets, and put 3 on each side of the back of the remote. This is to figure out the right polarity. The sides of the remote have different polarity. The sides of the magnets that cling to the remote should go towards the front of the part - i.e., they should be entering the pocket first.

The pockets are not separated by filament. To make the magnets stay in place, I had to use a drop or two of Loctite.

Follow the instructions of the T-nuts model for assembling the 2 T-nuts. Attach them to the part with the screws. Refer to the various graphics in the instructions for T-nuts for how to attach them properly and how to install the part on your Skadis.

Tagi