1 / 3
IKEA Trippevals blind flush mount with Klamby system
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement fitting for IKEA TRIPPEVALS blinds, works with KLAMBY components for flush mounting against windows
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 793
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement fitting for IKEA TRIPPEVALS blinds which allows them to sit flush with the window frame without the need for drilling. It is compatible with inward-opening and tilt windows. The print does not require supports and can be made with PLA, though higher temperature-resistant filaments are recommended if the windows are exposed to sunlight.
Required components
- IKEA TRIPPEVALS blind
- IKEA KLAMBY fittings (pack of two)
Installation instructions
- Remove the screw and mounting bracket from the KLAMBY fittings.
- Detach the transparent mounting clips from the TRIPPEVALS brackets.

- Insert the screw, mounting bracket and clips in the 3D print.

- Install the two new fittings on each end of the TRIPPEVALS blind.

- Hang the blind with fittings over the window frame and tighten screws. Optionally, press the cap on the screw to hide the screw.
