Adapter plate for LED afterburner for RC Avanti S Jet from freewing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter plate for printing or milling
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 299
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
There are LED afterburners for RC model jets which imitate the exhaust jet of an original turbine.
The LEDs are screwed onto the motor of the impeller. If the LED fits the holes, it can be mounted directly. If not, there are adapter rings which did not really fit in my case. Either the LED was mounted at an angle or not tight enough on the motor.
That's why I created a small adapter plate where the LED can be permanently mounted on the motor.
Countersunk head screws M3 must be used for installation. The countersinks for the screws must still be inserted into the panel.
You can print the adapter plate with a temperature-resistant filament, I milled the adapter plate from GFK sheet.
Assembly, see pictures