SV06 8015 80mm fan enclosure with MOFSET MOD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the STEP file from the original, and heightened to fit a 8015 Fan for the MCU, with mounting for 2x MOFSETs
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I modeled a spacer bracket so the door would fit with other part cooling solutions as well.
the honeycomb grille can be a bit tricky to print if you are on a .6 nozzle. it will not slice correctly unless you set your walls to .5 for the first layer, and add a cylinder modifier in Orca to adjust the wall line width to .5 for that area.
i used manual supports on the bottoms of the door hinges. support should not be needed anywhere else.
i used 2mm heatset inserts for the holddown bracket. i would reccomend getting everything wired up before you lock it down.
Also, i found out that my PA13 and PA14 pins both do not output enough voltage to run the mofsets. luckily i found out the unused pin on the BLtouch connection is programmable and provides Hardware PWM Control.
this only allowed me to run both fans at a single set speed, which works fine for my needs.
if you go this route, you will only need to wire up a single MOFSET. the extruder and MCU fan would both go into the output of that board and you can still use the Ground from the ICSP described in the original design.
Below is what my printer.cfg entry looks like. the fans will run at 50% as long as any of the heaters are active, or the extruder stepper is active. once it shuts off, it runs at 40% for 300sec then turns off.
[controller_fan e_sink_fan]
pin: PB0
max_power: 1.0
fan_speed: .5
hardware_pwm: true
#cycle_time: 0.01
kick_start_time: 0.100
shutdown_speed: 1.0
idle_timeout: 300
idle_speed: .4
heater: extruder, heater_bed
stepper: extruder