2.5" drive dual 2510 fan duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fan duct for 2.5" drives (espeically U.2 ones)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
I installed 2 U.2 disks to my tower PC case, which do not have very proper HDD cooling for the 2.5" mounts. So I added this fan duct to the disks.
As my PC case is designed to fit 2x2.5" or 1x3.5" at the same location, I designed this duct to be able to be around the same thick as a 3.5" drive, which leads to its utilization of 2510 fans.
The drive shown in the photos (and installed on my PC) is Intel D4502, and this fan duct is also designed to optimize for this drive, espeically its integrated heatsink. If the drive to be used is 7mm or 9mm thick, maybe adding an extra heatsink below it will be a good practice (not tested at all).
BOM:
4 M3x16 (or maybe longer if the installation position originally needs longer screws than M3x4) screws to install the disk with this fan duct at back
8 M2.5 heat inserts
8 M2.5x14 screws (M2.5x12 may work)
Drive and 2 2510 fans
My print settings:
Sunlu ABS, X Y scale 100.7%, rotating to get the face installing fans stuck to the plate