Soldering Flux Syringe Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sleek cap for a soldering flux syringe with needle
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 117
- Wydruki
- 0
- Wyświetlenia
- 381
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a quick and easy printable cap for a soldering flux syringe to keep the needle protected, prevent quick drying of the flux and it keeps stuff from getting sticky when storing the syringe.
The design requires no support, tho I would suggest to use variable layer-height if you are able to use it. top get some extra detail in the curves and to make the inside steps more neat. The provided MK4S bgcode already has the variable layer height applied to the sections where it profits from it. (See last picture)
The cap fits syringes with a base/thread OD of 10.5mm and supports needle lenghts of up to 20mm (see third image).
If there is demand for it, I can make a parametric version and publish it. For now I will leave it at this one version. If you need different dimensions, send me a DM or post a comment on the Makes section.