[OUTDATED] Thinner Thumper Blocks Filament Path with Pre-Gate Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As the title suggests :)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 250
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Not recommended to use - Thumper Blocks' filament path proven to be extremely fragile and it breaks during installation of the ECAS fitting, and same goes for this remix.
This is a (work-in-progress) modified version of a Thinner Thumper Block rev3 for a 9-channel ERCF v2. The modification is a filament sensor that is built directly into the channel. It calls for a 4mm bearing ball and the same D2F-01FL sensor as in https://www.printables.com/model/651002-k1-extruder-filament-runout-sensor .
TIP: you can install the swing lever onto your pre-soldered microswitches that came with the kit - that would be much easier than re-soldering the whole set.