IKEA Lack TV Bench Raisers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IKEA Lack TV Bench raiser, moves table top above (my) outlet height and shifts it back to be flush with the trim & wall.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
I made these slide on raisers for my IKEA Lack TV Bench to address two problems.
The main problem i was facing was the table top was exactly at the height of my outlets which meant I had to pull the table away from the wall to plug anything into the outlets. The secondary issue was the trim along the wall meant i could not push the table flush with the wall.
The front raisers are basic and only serve to raise the bottom of the table top to be above the outlet cover.
The rear raisers however is where the sauce is at, after some trial and error I came up with the profile of my trim. which was then removed from the back of the rear raisers, but in order to ensure the table top would sit completely flush with the wall I offset the leg cutouts to the rear of the raiser.
In order to reduce the material used, and increase the strength of the part I added a through hole with a draft.
First print the "Trim Fit Test" piece to make sure that the rear leg raiser will work with the trim in your house.
Would recommend supports for the flat part of the rear leg raiser's trim profile cutout.
Something similar to this is a great excuse to get into CAD modeling. My OnShape files are linked below. If you make your own raiser based on my design, please tag me!
https://cad.onshape.com/documents/0f418ef53c2eadb44c7c5b66/w/8c5c3007a6258fa4c3ad9a58/e/8d8ea08bc87bb957b150e53d?renderMode=0&uiState=6744b1020adb814d2234f335