6901 Bearing Extractor & Receiver for the Norco Fluid and others
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bearing extractor for many of the bearings in the Norco Fluid (my 2024) rear suspension and suspension pivot.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a custom bearing extractor and bearing receiver for 8 of the 12 bearings used in a Norco Fluid rear suspension. The other 4 bearings will require you punch them out or use a sliding hammer bearing puller sadly.
Additionally, the bearing receiver can be used as a very low profile “soft shim” when you're reinstalling bearings; particularly useful for the forward chain stays. The receiver is also helpful when you're reinstalling bearings as it will prevent damage to your bike's paint work.
This extractor might very well work for many other 6901 bearings, but all I've got is my fluid.
Prints without supports. I recommend 100% infill (solid) since it's so small, but feel free to experiment.
Print it in whatever you want. PLA and PETG have worked fine, it doesn't need anything more.
This is built around a bearing press/extractor with a 10mm shaft diameter. I use the one from Wheels MFG.