Base for DIY whip antenna 3/8 24 CB type bracket 10m vertical GP ground plane HAM radio HF
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
made to fit on a "CB" style adaptor base with isolators. i personally make a little alumilium bracket with radials.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 1229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
[Base for HF whip]
this is the BASE and COIL for a whip made from a 8mm fiberglass rod.
this is made for 3/8" x 24 bolt. sadly i dont remember the HEX head size. please be careful and measure it and compare before printing. everything is epoxy'ed togueder to make for a strong construction that is water tight. the use of the “CB mount” is required. you must solder your antenna wire onto your bolt… personally i twist the wire around the whip, it help getting a bit of inductance/capacitance and make for a tiny bit wider bandwith.
MATERIAL:
- 8mm fiberglass rod
- 3d printed base and optional loading coil
- epoxy glue
- 3/8 X24 bolt
- wire for antenna (ive used copper and alumilium wire)