1 / 2
Magnetized Holder for CNC Kitchen Threaded Inserts Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the "CNC Kitchen Threaded Inserts Soldering Tips Case" to attach to a metal surface via magnets.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Created this holder to attach the case to the inside of a metal drawer.
It has five slots for 15 mm (diameter) by 1,7 mm (thickness) magnets. Each slot has a little stud to keep the magnets in place and a cutout at the back to remove the magnets easily from the slots (e.g. using a pen).
There are two versions:
- the one with the lip is more stable when hung on a ledge (in my case the side of the drawer). It uses three magnets to be held in place (two would work too)
- the version without the lid can be attached to any magnetic surface but needs more magnets no not slip. four magnets worked, but five magnets were at lot more stable
Printed with
- PLA
- 0.4mm nozzle
- 0.2 mm layer height
- no supports needed
- standing upside-down (see photo)