1 / 1
VAOC Parts for Mandala VC4 Rear Arm (Updated Pocketed Arm) — zdjęcie 1

VAOC Parts for Mandala VC4 Rear Arm (Updated Pocketed Arm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified VAOC parts for the Rat Rig V-Core 4 that are compatible with the updated Mandala Rose Works Arms.

Ocena
0 / 5
Polubienia
10
Pobrania
112
Wydruki
0
Wyświetlenia
584
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Modified VAOC parts for the Rat Rig V-Core 4 IDEX to work with the Mandala Rose Works machined arms. Two of these parts are required, the rest are optional.

NOTE: This set is for the updated version of the arm with the insulator pocket for the vertical offset switch. A separate set for unmodified arms will be provided, but I recommend you get the updated arm if you have one of the originals.

Disclaimer: At this time, I have mounted these to the arm and checked to make sure there is no electrical continuity between any of the electronics and the arm itself. I have not finished the printer yet, but I will update when I have completed the first print or when someone else reports success.

 

The Parts:

  • Required
    • vc4_vaoc_body_pocketed_arm
      • The main body. Removes an obstructing feature and bevels an edge to avoid some screws
    • vc4_vaoc_duct_pocketed_arm
      • modification to the duct part that moves the side screw holes slightly to align with the new machined arm.
  • Optional
    • vc4_vaoc_vent_easy_print (optional)
      • convenience modification to make the overhangs of this part easier to print. tweaked because my parts kit from RR had droopy overhangs and my reprints had the same
    • vc4_vaoc_midframe_extra_space (optional)
      • modification of the midframe to give a little extra space for a wire connector that is a tight fit. I didn't need this after dialing in shrinkage, but providing it for others incase they want a try
    • insulator_insert
      • This is provided by Mandala Rose Works directly. I did not design it. This printed part is included with your order of the arms. This is here just as a convenience in case you lose yours, courtesy of Mandala

Printing tips:

Get your shrinkage dialed in for ABS/ASA!! There are a lot of electronics crammed into this assembly and screw holes to line up. Your life will be much easier if you compensate well for shrinkage. I recommend the CaliCross: https://www.printables.com/model/546871-calicross-a-handy-tool-for-3d-printer-dimensional-

Tagi