Book Case for Raspberry Pi 5 (Rpi5), Active cooler, 2 SSDs, and full-HDMI

(This is the thicker Dual SSD version of my Book Case.  I have also published a slimmer Single SSD version.)

I wanted a good case for traveling and taking my Plex Media Server with me.  My requirements for this case:

• All Ports on One Side
• 2 SSDs
• Full-Size HDMI
• Slim Case to save space when traveling
• Power Button accessible
• LEDs visible
• Good air flow
• As few supports as possible

This is the smallest case I could design to fit the Raspberry Pi 5, Active Cooler, Pimoroni Base Duo for 2 NVMe SSDs, and the Waveshare Pi5 Connector Adapter for full size HDMI and putting all the ports on the same side.  I use USB-C for power so I removed the green Screw terminal.  There is enough space to have a microSD card permanently in place but I don't need to access it regularly.  Power Button works and glows from the LEDs inside.  Case stands on end to save space and kind of makes it look like a book.  I haven't had issues with it throttling due to heat, even in tropical environments, so cooling must be working.  I used Black for the Cover and Purple Silk for the Pages.  

Requires:

Pimoroni Base Duo (including screws and standoffs for mounting) + 2 SSDs

Waveshare Micro HDMI to HDMI Multifunctional Adapter (Waveshare.com, amazon.com, etc.).  Remove the Green screw terminal prior to assembly.  It will come off with your fingers or a little heat from a soldering iron could help.

6-7 2.5mm heat-set Threaded Inserts for holding the board and closing the case

6-7 2.5mm Screws (shorter are better) for holding the board and closing the case

Washers (Recommended) to keep the Waveshare and Pimoroni board screws from loosening

4 or 8 felt feet for the bottom depending on which way you want to stand it up  (Cabinet Bumpers Furniture Bumpers Kitchen Cabinet Door Stoppers Sound Dampening Rubber Bumpers Made of Soft Eva Rubber for Quiet Drawer Close Anti Slam Cushion Rubber feet Pads 10 mm (50 pcs, Black)) (amazon.com)

Assembly:

Insert the 6-7 threaded inserts:  4 for the cover, 2 or 3 in the Pages section for attaching the boards (2 works fine, 3 likely more secure).

Assemble all the boards together first.  Insert the assembled boards in the bottom of the pages section, ports first, and slide up the other end of the board working it through the port holes.  Careful of the ribbon cable.  Screw in the 2 or 3 screws to hold the adapter board to the pages.  The raspberry section rests against the pillars but isn't screwed in.

Slide the Cover over and screw it closed.  4 padded feet can go on one or two sides of the pages section to keep it from sliding/scratching your desk.

I printed on a Mk4S with 0.15 layer height, 10-15% infill, PLA and Silk PLA for a pop of color.  pages is printed upside down with supports only on the USB and Ethernet ports.  Print Cover on end with a skirt and without supports.