Creality Falcon2 Pro - Exhaust Fan Gasket DXF (no more smoke leaking out!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creality Falcon2 Pro - Exhaust Fan Gasket DXF
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 578
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had smoke creeping out the crack between the exhaust hose adapter and the side of the enclosure as well as the hose connection where the wire wraps. I replaced the fan grill with this foam gasket cut from 2mm craft foam. If you want to leave the grill in place, I'd recommend cutting two gaskets and putting them on both sides of the grill. You may need longer M4 bolts then.
I still had smoke coming out the hose connection. There is a wire in there you can't clamp flat to seal and it creates an opening for the smoke to get out since that's all under pressure from the fan, so I wrapped the hose connection with tape and that eliminated any smoke getting out there so it all goes out the end of the hose now.
I picked up an 8 ½" x 11" sheet of foam from Michael's Craft store and cut this gasket from it.
I cut this with a 40W laser at 3000 speed and 20% power in a single pass in Lighburn.